At first glance, all aftermarket Corvette fiberglass body panels may look the same. During the 1980's and 1990's, several aftermarket companies tried reproducing replacement body panels for America's favorite sports car. However, many short cuts were taken to save costs. The end result were body panels full of air bubbles and waves. The amount of prep work required was time consuming and frustrating for body shops and expensive for consumers. Even worse, these fiberglass body panels didn't have reinforcements so long term durability was compromised. That may be fine for a race car but definitely not OK for a driver, show car, or investment.
The result is the finest quality fiberglass body panels that fit right the first time and with minimal prep work required. They are NOT built using a chopper gun as with cheaper imitations. 5ounces of mat and 21 mils of soft sanding gel coat. All of this eliminates hassles, frustrations, and disappointments while saving you valuable time and money.
NOTE: Fiberglass panels require fitting, trimming, shimming, and special finishing. Our DVD's are loaded with helpful fiberglass prepping and finishing tips that will help you finish your project right.
| Make | Model | Years |
| Chevrolet | Corvette | 1956 - 1960 |
