Is your radio getting poor reception or no longer working for AM/FM stations due to a worn-out or broken power antenna in your vehicle? Replace it with this 31" (79cm) 5-section chrome power antenna so that you can enjoy clear radio…
Electromag Hidden Antenna, designed for optimum AM/FM reception. Excellent solution for Streetrods, Show Cars, Classics or any vehicle where a conventional antenna is not desirable.
…
Protect your antenna base and maintain a clean seal with this antenna bezel gasket, designed specifically for 1963-1982 Chevrolet Corvette models. This factory-correct rubber gasket provides a snug fit around the antenna bezel, preventing…
This Corvette reproduction antenna nut has been manufactured to original factory specifications using today's modern manufacturing techniques. You will find the fit, finish and function will work superbly for your…
Tapered mast as original (.100 at ball; .185 at mast).
Has correct .305 size ball.
This stainless steel antenna mast measures 31 1/2 inches overall length, with a thread size of 1/4 inch x 20.
…
This die cast, chrome plated spacer is angled.
The short side is 1/4 inch tall.
The tall side is 7/16.
O.D. = 1 5/16
I.D. = 3/4
There is a flange at the bottom which fits/snaps into gasket 162039
There is also a locator pin…
Correct reproduction zinc diecast chrome plated antenna nut used on all 65-68 Corvettes.
This antenna nut cap has the correct flats on the side of the nut and stepped lower edge where the nut mounts on top of the antenna bezel.
Hole…
Antenna Assembly, Manual
Includes Ground Strap and Instructions
Retracts as Original
Exact Above Body Appearance as Original
Note: Does not include Nut, Bezel or Gasket as Shown in Photo
…
Reproduction Of Original
The mast section of the antenna consists of four round chrome sections, three telescoping sections, and one fixed section, with an approximately 1/4" ball-shaped tip at the end of the mast. The overall…
Protect your investment with an Original Fender Gripper. They offer the highest degree of protection from impact and scratches while you work on your car. Each Fender Gripper is made from a unique reinforced foam padding that provides…
Reproduction Of Original
Saves Price Of New Antenna
Easy To Install
Cable Attached To Mast
NOTE: Use With Original Antenna Numbers 1978-82 All Without CB, 1984-5048853, 1985-5048926, 1986-87-5048760 Or 5049063. If The…
The advent of power accessories on automobiles through the 1950s and 1960s added a new premium driving experience to cars with functions at the press of the switch or button. A sleek, high-tech improvement to your classic or collector…
If the antenna motor is still working, this kit will repair your antenna 99% of the time. Usually, the plastic flexible extension cable snaps, which obviously makes your antenna inoperative. This kit includes a new cable attached to the…
1969-1978 Corvette antenna mast retainer nut has 1/2 inch x 20 threads. Nut is 7/16 inch tall . Has 9/16 inch wrench flats. Top hole measures 0.414 inch ID.
RETAINING RADIO AERIAL MAST
…
This antenna is an exact replacement for the Harada XM010. All the same quality as the original Harada unit. Top quality relay that controls the unit.
Universal Unit
5 Custom Head Kits, 4 Section Ext, 31"…
Don't replace your power antenna if all you need is the mast! Most power antenna units are needlessly replaced when a less expensive remedy could cure them. If the motor on your power antenna is still functioning, but your antenna mast is…