This bearing is used for the tilt and telescopic steering column shaft. Two are required, as it is the same upper and lower.
This bearing is 1.570 inches outer diameter x 1.108 inch inner diameter x .332 inch thick.
CORVETTE TELESCOPIC…
By the late 1950s, Chevrolet’s passenger car lineup had grown in size and power. The combination of these factors places a great duty on the steering system of these vintage bowtie vehicles. This lower mast jacket steering column bearing…
This upper steering column roller bearing fits inside the cast housing that the turn signal switch mounts to. This is for 64-66 Corvette standard steering columns. For 65-66 telescopic column bearing use part #562063CORVETTE COLUMNS…
This spring is on the upper steering shaft. It rests against the upper bearing. It fits inside of the turn signal switch – it doesn’t touch it. This spring provides the upward pressure on the lock plate.
Dimensions: Total height =…
This bearing has a rubber collar around the outer circumference. It also has a ground wire with a terminal attached. The wire has a black woven covering. The outer diameter of the rubber collar is 1.669 inches. The outer diameter on the…